'07 Mazda 3

What and where would I find a dome light housing that would hold an Oznium Dome light?

Mmm basically in your car, up on the roof, pop the plastic cover off and that is your dome light housing. Measure the insides with a tape measure, calipers, etc.

I have an '08, I got the 194 bulbs for the front two lights (these) and one of these for the dome light. Works out well, and if you put the strip in right, it doesn't look like crap.

Phil wrote:

Mmm basically in your car, up on the roof, pop the plastic cover off and that is your dome light housing. Measure the insides with a tape measure, calipers, etc.

HoolaKinG wrote:

I have an '08, I got the 194 bulbs for the front two lights (these) and one of these for the dome light. Works out well, and if you put the strip in right, it doesn't look like crap.

The legth across the domelight is only 2 1/4". how did you manipulate a 6" stip in there???

Phil wrote:

Mmm basically in your car, up on the roof, pop the plastic cover off and that is your dome light housing. Measure the insides with a tape measure, calipers, etc.

The Oznium "Dome Lights" measurements are too large for this dome light housing. I am looking into the ribbon leds. Thank you all for your help and imput

You sure 1.5" x 1.0" is too big?

http://www.oznium.com/thin-led-domelight

I folded it over and over on itself to make it fit. They are flexible little suckers...