ICELED Zen Controller

All Customer Questions

Question

Does the zen have the same non-volatile memory as the zap? So all the settings are saved when you turn it off? - by Spawn (Toronto)

Answer

Yes

Question

do you have to use yellow in the patterns

Answer

No, you do not have to use any color unless you want to.

Question

It says there is a Direct line-input for Audio light show. How does this connect to my audio? - by Wesley (Virginia)

Answer

You can plug in a line-input standard 3.5mm headphone plug into the Zen controller. Generally, if you have an aftermarket stereo in your car, you can just plug an RCA cable into the back of it, and then run that to the Zen controller.

If you don't have an aftermarket stereo in the car, you can always just use the Zen's built-in microphone for audio response.

Question

Is there a limit to the number of Iceled lights you can hook up to the Zen controller? - by calvin

Answer

The Zen controller can handle up to 5 amps (quite a bit!). If you need to control more than that, you can simply use a relay.

Question

Do I just hook up the Zen controller to the battery and hook all the lights up to the controller? - by calvin

Answer

Yes

Question

by the looks of it the zen controller has all the features of the ufo kit and then some, am i correct? the reason i ask is that the ufo is way too expensive for my salary and i was hopeing that if i biought the zen then one tube at a time (amongst a but load of trons) that i could have an equal to your ufo kit. - by sean (leesburg florida)

Answer

That is a bad idea. The ZEN controls 4 zones of a single pixel color, it does not provide data for scanning patterns.

Question

The description for the Zen controller states that it can control up to 16 different ICELED products. But the ZEN only has four zones. Can each "zone" handle four ICELED products? And if so, would that mean I could use zone 1 for my trunk, zones 2 - by Steve (Michigan)

Answer

Yes, yes, yes!