Mine stopped working

Okay, so I hooked the Fusion Kit up to my car and everything and played around with it for 5 min. changging the colors and patterns and then it stops working. 1st it won't change from blue and then it just stops working completely. On the controller the indicator lights for the colors don't work anymore along with the tubes, but the pattern indicator lights still work and u can switch through those. I'm so mad now I finally got it hooked up and I can use it.

sorry to hear that man....i guess you should send in the warranty card so you can get a new one...btw what do you drive....because im trying to find out if i should try to hook mine up without the extension cable....but if it wont be long enough without one then there is no point....you see my truck in my sig...compared to the size of what you drive what do you think my chances are of getting it to hook up without extra cables

I have a K-5 Blazer and didn't use extension so I don't think you'll need em either. The wires are kinda tight though. It also depends on how far back you mount the rear tube. I couldn't mount it all the way in the back so its about a 3 feet or so towards the center of the car, the exhaust and gas tank got in the way.

Sorry to hear that... Call up PG on monday and they might know what is wrong.

I tried again later yesterday and this time each time I switched colors they would flicker on for 1 sec. Then stopped working again. I'm gunna try again today with a better ground.

Sorry to hear that knox!

Hopefully it is just a bad ground connection..
Do you have the remote mounted to a flat surface,we were having problem with it staying white with a rainbow effect with the other colors..
The area where we mounted it wasn't completely flat and once we put it on a flat surface it worked perfectally fine..
I sure do hope you find the problem..

I dont even have the controller mounted, I just pick it up and push the buttons.