Fusion underbody install help

I will probably be installing my kit in a couple weeks as soon as it warms up...my question is....what is the best way to install/aim them....i was thinking these were my options:

#1) Put side tubes next to each other in the middle of the car and point outwards with the 2 end tubes as far in to the middle as possible and then point to the front/back

#2) put all tubes as far to the edges as possible and aim straight down (a little out)

#3) Place side tubes on edges and face to glow across the car out to other side and place front/back tubes closer to the middle and point to front/back

Let me know how you've installed them and if it looked good or what you wished you would have done instead..
Thanks for your help,
adamtmo000

Hello everyone, first time poster here!
Since we are on the subject of installation help....
I lost my instructions on how to install the fusion led kit
could anyone scan it for me and send me it please?
Thanx!

adam: the first thing you said was the best one to go with but you probably dont have to put them close to in middle if you car is high enough that the glow will come out a good bit...try putting them closer to the side but pointing outwards that way the glow goes farther out....DO NOT POINT THEM DOWN..it will look very bad..and if you point each one to the opposite side i think it will look like a it a blue line SG kit...thats what i was told

THUGSTA:do you really need the instructions??...it is very easy to hook up..just mount the tubes where it will give the best glow....take the white plug on the ends of thecables coming off the tubes and plug them into the little black distribution block that has 6 slots...mount that somewhere safe from water and heat but make it easy to get to....then take the rainbow ribbon wire and hook that from the distribution block to the control box....then ground the black wire and use the red to wire and run it to one of the prongs on the switch...then from the other prong run some wire from that to the battery with a inline fuse within 18 inches of the battery...its not hard

the whole thing took me and one friend like 2 1/2 hours,it would have went faster but my truck was hard to get under since its low so that slowed us down...........good luck

ZxTHUGSTAxZ wrote:

Hello everyone, first time poster here! Since we are on the subject of installation help.... I lost my instructions on how to install the fusion led kit could anyone scan it for me and send me it please? Thanx!

I e-mailed you the instructions.

Welcome ZxTHUGSTAxZ!

PT: If you email me the instructions I will post them on the site.

Phil wrote:

Welcome ZxTHUGSTAxZ! PT: If you email me the instructions I will post them on the site.

Phil, I e-mailed the instructions to you.

i know nothing about cars and installing things
but my friend who has some knowledge about installing things is helping me out. its getting harder and harder, more and more time consuming then we thought. It took us 2 damn days just to get to the firewall. my friends got me this kit for my b-day and im putting it on a benz c-class 02 (i think im the only one in the world whos gonna have one on a benz) haha. But mercedes makes it so hard to accesorize its cars. so thats y i need the instructions
thanx for sending them pt!

It should look good on your car Be sure to post some pictures when you get a chance.