PG Amps

car stereo shop...

they must have scoped out the store before... they knew what to get

the Frank Amp'n Stein *bows down* and the MS1000

http://www.phoenixgold.com/webfaq/MS_Special.htm

they got a McIntosh MCC602TM amp...

i meant $8,000... my bad

that amp is wierd lookin

banned from SG wrote:

knox, fab one up urself!

Tell me how and I will.

aluminum foil and a coat hanger

what, the mcintosh??? or the frankampenstein? they're worth $3,000 and $2500 respectively... it's a classic... and for all you alpine type R fans... that franampenstein can push about 6 of them to full power....



per channel....

and it's a four channel amp.


and the mcintosh has a T.H.D between .001% and .0045%... fosgate typically does .05% that's the clearest amp you can buy... absolutely no distortion present...

that frank thing. it looks like a circuit board in plexiglass. but apparently nothin to sneeze at how did your shop get your hands on one? i think that sight said they only made 300?

we sell the most phoenix gold in the nation...

we pre-ordered their 10,000 watt amp...


not a typo... 10,000 watts... can't disclose details...

www.phoenixgold.com ... they'll post it on the web page when it's all sorted out.

whats the world coming to?!?!

10,000 watts is just insane

dbismyname wrote:

whats the world coming to?!?! 10,000 watts is just insane

yea that could run 18" 2 solo X's

I want it.

ADDICTED2ICELED wrote:

what, the mcintosh??? or the frankampenstein? they're worth $3,000 and $2500 respectively... it's a classic... and for all you alpine type R fans... that franampenstein can push about 6 of them to full power....per channel....and it's a four channel amp.

sorry i have to go change my pants...

i wish i had one of those

i know mav will flip about that Mcintosh... he seem the audiophile type...


now this new amp... well you would be wasting your time pushing type R's.... it could push about 8 W-7's

then there's the MPH6300. here's phoenix gold's specs on that...

note... this thing is stable down to 1 ohm. and has a backbone that can demand 700 amps of power.

MPH6300 SPECIFICATIONS:

Into 4 ohms @ 12.5 or 14.4 VDC
75 WRMS x 6

Into 2 ohms @ 14.4 VDC
150 WRMS x 3

Bridged into 4 ohms @ 14.4 VDC
300 WRMS x 3

Frequency Response
+/-.5dB from 20Hz to 50kHz

Signal to Noise Ratio
>110dB

Input Sensitivity
200 millivolts to 2 volts

Input Impedance
>30k ohms

Input Voltage Range
10.5 volts to 15.0 volts

Typical current draw at idle
3 amps

Minimum Impedance
2 ohm bridged/1ohm stereo

Crossover Frequency
32 to 400 Hz

Crossover Slope
Selectable 6, 12, 18, or 24 dB per octave

Dimensions, MPH6300
46"L x 14.5"W x 4"H

Weight
115 Lbs.




What is the MPH6300 and does it really exist?

The MPH6300 is literally a one of a kind amplifier. In fact, there is only one ever made. This amplifier has set the standard of unsurpassed quality that Phoenix Gold amplifiers are known for. The amplifier itself is a hand built six-channel amplifier that uses only the finest audiophile components available on the earth. The switching power supplies are fully copper shielded and isolated from the audio circuits, not to mention the shields are plated with 50 microns of gold to protect from corrosion. All 24 of the 250 watt/50 amp output transistors have been "gain matched" Mil Spec T0-3 power devices. All 18 of the 250 watt/70 amp Mosfet Switchers are "gain and beta matched" Mil Spec TO-3 power devices. It also features a discrete full complementary output design. The amplifier also includes an independent 3 band parametric equalizer. This all adds up to an amplifier that weighs 115 lbs. and has a legendary reputation.



Can I buy a MPH6300 and how much would it cost?

The MPH6300 is not for sale, it’s a one of a kind collector's item. However, it does have a retail price of $99,000.

http://soundoff.phoenixgold.com/viewtopic.php?t=597

these are pics of it....

with my past addition to PG being as bad as my current one to iceled... I would have bought it @ $99,000 just to have one...

If only I were rich... Clarity would be mine!.. that's all I gotta say.. *grin*

As for the Frankenamp.. that thing is insane.. 540 WRMS per channel x 4 at 2 ohm @ 14.4v... 1 channel at 2 ohm and 1 channel at 4 ohm could power my entire car setup =P and I'd still ahve power to spare on those 2 channels, plus 2 additional unused channels... *bows down*

holy frickin' hijacked post, batman.


justin.

Hehe - Split!

you pulled a fast one there

I'm sly like that.

The 3rd post in this topic by me still belongs in the steering wheel topic. It has nothing to do with the amp.

Oh shush, it was quickly done.

Aken wrote:

Oh shush, it was quickly done.

Don't be so hard on yourself. I don't really care anyway I was just sayin...