Any PlasmaGlow Techs on this forum?

I remember reading a post from a PlasmaGlow tech on this forum. So I'll ask the question. Do you have a schematic or could tell me where to pick up a switched (on with unit on) +12 volts on the circuit board for the Fusion Wireless Upgrade. Heavy Duty Controller would be the best, as I'm working switching a external relay when the unit turns on by remote control or ON/OFF button.

Thanks.

Well, I figured it out on my own. It seems the Fusion Wireless upgrade control box uses 12 volts to drive the LED tubes, but converts all the control signals and remote circuit to 5 volts with a PCB mounted voltage regulator. So, I just used a small 5VDC reed relay to switch +12 volts out of the wireless control box.

This is all done so the LED tubes mounted under the sides of my car will operate with the interior lights. For example when pressing the unlock button on the key it will also light up my side tubes (in selected color). When the Fusion Wireless control box is turned ON via remote or control box button the kit will light all tubes as normal.