Frozone's video question and answer thread

Tat2Dragons wrote:

PwrRngr wrote: I know on all the vehicles I've had the cigarette lighters (not the power outlets) are on all the time. That way someone can light there cigarette w/out having to turn the key on. Hmm...I've actually had three vehicles that the cigarette lighters were on a switched circuit.

Same. Never been in a vehicle that don't have the cigarette lighter on a switch circut.. This prevents someone draining the battery if someone has something hooked in there when they leave the vehicle.

Dude this frozone guys is awesome! Stick around man!

Thanks drift. when i have my card on me i'm going order more interconnects and finish the project. in the grill

Haha. Nice closing video man, looks good!

So for those that would like an update.....
http://www.youtube.com/watch?v=9ir3A-3QoOk

Thar you go.

Looks good,but you should cut that excess off your zipties.Also,black zipeties would look a tad better. As for you turn signal wires,I don't know for sure,but they could be two positive wires(one for turn signal and the other for a parking light) the last wire probably is a ground. Get yourself a inexpensive multimeter and probe around to find out for sure as to what they actually are. Once you have identified those wires,wiring them up to your custom l.e.d.s is quite simple.
Good Luck.

ok revamping it. i got my flexible leds. so im all set. i decided for the R8 side vent look on my xb2 to go and try to crimp the lights so they turn on with my parking lights. however. there are three wires coming from that lamp. white blue and green. which one do i tap my red power from the leds into? i want them to blink, and turn on just like the bulb its splicing into. one has to be ground right?

DJ FroZone wrote:

ok revamping it. i got my flexible leds. so im all set. i decided for the R8 side vent look on my xb2 to go and try to crimp the lights so they turn on with my parking lights. however. there are three wires coming from that lamp. white blue and green. which one do i tap my red power from the leds into? i want them to blink, and turn on just like the bulb its splicing into. one has to be ground right?

Yeah one should be ground and the other two are more than likely 12volt+ turn signal and 12volt+ parking lamp. You would connect your red 12volt+ to one of those two wires. You should check them with a meter to make sure which is which.

DJ FroZone wrote:

btw where in ohio r u? im from Cincinnati OG.

hey i live about 40 minutes from Cincinnati

yea trenton! i currently am in NY going to school but i do know that trenton area.

DJ FroZone wrote:

yea trenton! i currently am in NY going to school but i do know that trenton area.

yeah awesome when you get back down in the area let me know

http://www.scionlife.com/forums/showthread.php?t=174025

Update