For A-Ray V2 How To

Its a little late dont know if you still need it or not but just wrote this up real quick...any questions let me know


How to Create and Store Custom Colors On Flowlighting Inferno V2

1.Turn On
2. Hit the normal button until you stop at A9
3. Hit the CA button until you see b0-9
4. Hold down the T/E button for about 2 seconds
5. At this point either an E will show up or number 1-5
If you want the whole tube to be the same color hit the T/E button until it displays E
If you want a separate color, 1-5 allows to create an individual color per group of L.E.Ds.
6. Using the R.G.B button. Press the R.G.B button and either a half H will show up for Red Pixels, g for Green and b for Blue
7. Once you select either Red Green or Blue you can change the amount of color you want by using the + and – buttons. + to increase and – to decrease obviously.
8. Once you are done with one color you can use the R.G.B button again and repeat step 7.
9. Once you get the color you want if you are in the E mode just turn the power off using the remote, this will store this color under b0-9.
10. If you are using individual groups of L.E.Ds do the same thing in steps 1-8, but after step 8 use the T/E button to change the group 1-5.
11. After changing the colors on all groups turn the power off using the remote and the different color variations will be saved on b0-9 whichever one you chose.

Really, I don't need it since there is a V2 pdf on the store page.

But at least you got around to it!

I might need it thanks!

I'm in the process of writing an in depth How-To for the Wheel Well Kit, which should also apply to the V2 since they are essentially the same.

Where is this v2 pdf?

http://www.oznium.com/images/Inferno_V2_Instructions.pdf